SFXC Binder - SFXC | Special Effects and Coatings
£3.00

Our extra-soft print base is a perfect medium for printing bright colours onto white or light coloured cotton or poly-cotton blends.

When coloured by 6% pigment, this product offers excellent wash durability.

It is not recommended to use a pigment load of over 6% as this could damage the durability of the product.

If you are printing designs using multi colours always avoid using flash cure units in between.  It is best to print wet on wet

When coloured with upto 6% pigment, this product offers extremely good wash durability. It is not recommended to use a pigment load of over 6% as this could damage the durability of the product.

Please take a quick look at our exciting range of special effect pigments.

It is best to use 3-4mm off contact and to print the colours with a single stroke. It is very important that the product penetrates the fabric. The squeegee pressure and speed can be adjusted where necessary.

The recommended mesh count when using this binder is 43-77T (110-200) mesh. For halftones and fine details use the higher count and for the larger open areas use the lower mesh count. 

A medium shore rectangular squeegee is recommended.

Please use a water resistant emulsion for the stencil.

When the printing is complete the fabric must be cured at 165C for 2 to 2.5 minutes.

To clean up, use water and a light detergent.

The MSDS is available upon request.

Store the sealed container in a cool place between 7C and 24C.

All information is given in good faith and without warranty.

Customer Reviews

Based on 1 review Write a review